The graph shows this property’s current and potential energy efficiency.
Properties are given a rating from A (most efficient) to G (least efficient).
Properties are also given a score. The higher the number the lower your fuel bills are likely to be.
For properties in England and Wales:
the average energy rating is D
the average energy score is 60
Breakdown of property’s energy performance
This section shows the energy performance for features of this property. The assessment does not consider the condition of a feature and how well it is working.
Each feature is assessed as one of the following:
very good (most efficient)
good
average
poor
very poor (least efficient)
When the description says “assumed”, it means that the feature could not be inspected and an assumption has been made based on the property’s age and type.
Feature
Description
Rating
Wall
Cavity wall, as built, no insulation (assumed)
Poor
Wall
Timber frame, as built, insulated (assumed)
Good
Wall
Cavity wall, as built, insulated (assumed)
Good
Roof
Pitched, 300 mm loft insulation
Very good
Roof
Pitched, insulated (assumed)
Good
Window
Fully double glazed
Average
Main heating
Boiler and radiators, oil
Average
Main heating control
Programmer, room thermostat and TRVs
Good
Hot water
From main system
Average
Lighting
Low energy lighting in all fixed outlets
Very good
Floor
Solid, no insulation (assumed)
N/A
Floor
Solid, limited insulation (assumed)
N/A
Secondary heating
Room heaters, dual fuel (mineral and wood)
N/A
Primary energy use
The primary energy use for this property per year is 182 kilowatt hours per square metre (kWh/m2).
What is primary energy use?
Primary energy use is a measure of the energy required for lighting, heating and hot water in a property. The calculation includes:
the efficiency of the property’s heating system
power station efficiency for electricity
the energy used to produce the fuel and deliver it to the property
Additional information
Additional information about this property:
Cavity fill is recommended
Environmental impact of this property
This property's current environmental impact rating is E. It has the potential to be C.
Properties are rated in a scale from A to G based on how much carbon dioxide (CO2) they produce.
Properties with an A rating produce less CO2 than G rated properties.
An average household produces
6 tonnes of CO2
This property produces
9.8 tonnes of CO2
This property’s potential production
4.2 tonnes of CO2
By making the recommended changes, you could reduce this property’s CO2 emissions by 5.6 tonnes per year. This will help to protect the environment.
Environmental impact ratings are based on assumptions about average occupancy and energy use. They may not reflect how energy is consumed by the people living at the property.
How to improve this property’s energy performance
Potential energy rating
B
Making any of the recommended changes will improve this property’s energy efficiency.
If you make all of the recommended changes, this will improve the property’s energy rating and score from D (55) to B (83).
What is an energy rating?
An energy rating shows a property’s energy efficiency.
Properties are given a rating from A (most efficient) to G (least efficient).
Properties are also given a score. The higher this number, the lower your CO2 emissions are likely to be.
Recommendation 1: Cavity wall insulation
Cavity wall insulation
Typical installation cost
£500 - £1,500
Typical yearly saving
£141
Potential rating after carrying out recommendation 1
band-d
59 | D
Recommendation 2: Floor insulation (solid floor)
Floor insulation (solid floor)
Typical installation cost
£4,000 - £6,000
Typical yearly saving
£98
Potential rating after carrying out recommendations 1 and 2
band-d
62 | D
Recommendation 3: Replace boiler with new condensing boiler
Condensing boiler
Typical installation cost
£2,200 - £3,000
Typical yearly saving
£105
Potential rating after carrying out recommendations 1 to 3
band-d
65 | D
Recommendation 4: Solar water heating
Solar water heating
Typical installation cost
£4,000 - £6,000
Typical yearly saving
£47
Potential rating after carrying out recommendations 1 to 4
band-d
67 | D
Recommendation 5: Solar photovoltaic panels, 2.5 kWp
Solar photovoltaic panels
Typical installation cost
£3,500 - £5,500
Typical yearly saving
£368
Potential rating after carrying out recommendations 1 to 5
band-c
72 | C
Recommendation 6: Wind turbine
Wind turbine
Typical installation cost
£15,000 - £25,000
Typical yearly saving
£695
Potential rating after carrying out recommendations 1 to 6
The estimated cost shows how much the average household would spend in this property for heating, lighting and hot water. It is not based on how energy is used by the people living at the property.
Heating a property usually makes up the majority of energy costs.
Estimated energy used to heat this property
Space heating
22664 kWh per year
Water heating
3008 kWh per year
Potential energy savings by installing insulation
Type of insulation
Amount of energy saved
Loft insulation
125 kWh per year
Cavity wall insulation
2708 kWh per year
You might be able to receive Renewable Heat Incentive payments. This will help to reduce carbon emissions by replacing your existing heating system with one that generates renewable heat. The estimated energy required for space and water heating will form the basis of the payments.
Contacting the assessor and accreditation scheme
This EPC was created by a qualified energy assessor.
If you are unhappy about your property’s energy assessment or certificate, you can complain to the assessor directly.
If you are still unhappy after contacting the assessor, you should contact the assessor’s accreditation scheme.
Accreditation schemes are appointed by the government to ensure that assessors are qualified to carry out EPC assessments.
RdSAP (Reduced data Standard Assessment Procedure) is a method used to assess and compare the energy and environmental performance of properties in the UK. It uses a site visit and survey of the property to calculate energy performance.
This type of assessment can be carried out on properties built before 1 April 2008 in England and Wales, and 30 September 2008 in Northern Ireland. It can also be used for newer properties, as long as they have a previous SAP assessment, which uses detailed information about the property’s construction to calculate energy performance.
Other certificates for this property
If you are aware of previous certificates for this property and they are not listed here, please contact us at mhclg.digital-services@communities.gov.uk or call our helpdesk on 020 3829 0748.
There are no related certificates for this property.